View source for Template:Setting and checking the operation of the counter

==Setting and checking the operation of the device==
# Go to https://baozam.net
# In the ''Inventory'' section, click the ''Tuner'' button of the target device. You will be redirected to the device's ''Tuner'' page. The device will go into the ''Setup mode'' after the next transferring data to the cloud.
#* The device sends the data to the cloud every five (5) minutes. The device immediately reports about cutting/opening the beam, turning on. To avoid waiting for five minutes, you can: a) cut off the beam - a message in 15 seconds, b) turn off/on the device.
#* Within maximum 5 minutes the device will come into the ''Setup mode'' you will get a message at the ''Tuner'' page, and all device parameters will be displayed.
#* Press ''Pass Counter'' button under right blue buttons to see device's parameters.
# Click the ''blue'' parameter to view the ''Stream & Monitor'' buttons.
#* ''Stream'' - on/off sending this parameter to the cloud.
#* ''Monitor'' - on/off immediate displaying parameter values in the ''Monitor'' box on the page.
=== You should check: ===
If the emitter beam hits the receiver sensors (parameters ''left sensor'' & ''right sensor'').
* Turn on sensor monitors. Normal values range 5 - 6. 
* If the reading is less than 5, the emitter and receiver are not aligned or something breaks the beam. Adjust the alignment, clean the beam path. 
* If values are greater than 7 look for the source of noise.

The direction of the entrance/exit.
* By default, the input direction is from left to right relatively to the receiver.
* Turn on monitoring parameter ''count_in'' & ''count_out''. Break the beam ... 
* Change the direction by using the ''Mode Control'' button. Use the drop-down button ''LEFT to RIGHT is ENTER'' or ''LEFT to RIGHT is EXIT'' to select the desired direction.

'''Important!''' If you have changed any parameter, be sure to save the changes (''Settings'' --> ''Save''). Otherwise, when you turn the device off your settings will be lost.

[[Category:PCounter]]