Iridium mono 2k IR 1040 06 V4 - Error messages
From Awesome Baozam
ERROR MESSAGES
They are signaled by a sound and light series of short repeating beeps and blinks. The number of "beeps" characterizes the type of error. Error messages also indicate that the system can not register the tag in the system's detection area. The errors are also displayed on the display.
| N of beeps | Type of error | Removal method |
| 1 | internal electronics board error | call service. |
| 2 | a tag permanently within reach of the system | remove the tag. Light signaling only |
| 3 | absent synchronization at SYNC IN input in SLAVE mode | check the synchronization cable. Light signaling only |
| 4 | network synchronization absent | call service if the board is powered by AC / AC power adapter, or change Transmitting mode to trNo - InFr if the board is powered by a DC source. |
| 5 | very weak detection | There is an object with strong resonance nearby |
| 6 | interference in the system area is large | if the Gain is set to manual (NanU), lower the antenna gain by tuning the parameters Manual Gain 1, 2 (NAG1, NAG2 ). If the Gain is set to GAIn – Auto, call service. |
| 7 | no free interval for transmission | Set the parameter Delay Mode to manual (dENo – NAnU). If the Delay Mode was already set to NAnU, call service |
| 8 | internal error | call service |
| 9 | internal error | call service |
