Iridium mono 2k IR 1040 06 V4 - Error messages

ERROR MESSAGES

They are signaled by a sound and light series of short repeating beeps and blinks. The number of "beeps" characterizes the type of error. Error messages also indicate that the system can not register the tag in the system's detection area. The errors are also displayed on the display.

N of beeps	Type of error	Removal method
1	internal electronics board error	call service.
2	a tag permanently within reach of the system	remove the tag. Light signaling only
3	absent synchronization at SYNC IN input in SLAVE mode	check the synchronization cable. Light signaling only
4	network synchronization absent	call service if the board is powered by AC / AC power adapter, or change Transmitting mode to trNo - InFr if the board is powered by a DC source.
5	very weak detection	There is an object with strong resonance nearby
6	interference in the system area is large	if the Gain is set to manual (NanU), lower the antenna gain by tuning the parameters Manual Gain 1, 2 (NAG1, NAG2 ). If the Gain is set to GAIn – Auto, call service.
7	no free interval for transmission	Set the parameter Delay Mode to manual (dENo – NAnU). If the Delay Mode was already set to NAnU, call service
8	internal error	call service
9	internal error	call service