Iridium mono 2k IR 1040 06 V4 - Description of measured data control

The control of measured data is the default display mode. In this mode, the serial number of the displayed data is displayed for about a second, then the data value is displayed for about six seconds – the listings are alternated in this way. After about two minutes of inactivity (no button pressed) the display switches to sleep mode (turns off). You can re-display the most recently displayed data by pressing any of the +, -, SAVE or SELECT buttons. Use the +, - buttons to display the individual data as follows:

1. input signal level – channel 1, in % (default setting)
2. input signal level – channel 2, in %
3. average background signal level – channel 1, in %
4. average background signal level – channel 2, in %
5. level of permanent resonance in the input signal – channel 1, in %
6. level of permanent resonance in the input signal – channel 2, in %
7. automatically set increments (in %) in the GAIn – Auto mode – channel 1
8. automatically set increments (in %) in the GAIn – Auto mode – channel 2
9. portion of the input signal (in %) with a value sufficient for alarm – channel 1
10. portion of the input signal (in %) with a value sufficient for alarm – channel 2
11. total number of alarm level exceedings in channel 1, alternating with the value for channel 2 (the value for channel 2 includes a decimal mark at the end for the purpose of distinguishing between the channels). The measured data can be reset by switching the electronics off and on again or by remote control through the internet.
12. total number of alarms. The number can be reset by switching the electronics off and on again or by remote control through the internet.